Page 13<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 63632
?@<6AQRS6;@ACRED@CEA6E@ET6 ?6AFS
C8#$,77"83%,%A.(*,9*9%@44*##&(>
AR%S;6!6EA%CEjF;Q-%%U*,(%.*,Y>K9'$>%)&(Z%37&Y*#%).*8%.,897"83%)"(*%).**7#%,89%+('#.*#1%%%
A.*#*%,44*##&("*#%,(*%#.,(/%,89%4,8%4,'#*%"8='(>1
1. The accessory MUST be:
• rated to at least 7000 RPM.
• no larger than 4-1/2" (115 mm) in diameter.
• fitted with a threaded opening of 5/8" x 11 TPI.
• undamaged.
• a sanding disc and backing pad, or
a sanding flap disc; a wire wheel, or
a wire cup brush; (accessories not included).
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and the
Inner Flange and keep in a safe place.
4. Thread disc accessory firmly onto the Spindle.
Wrench tighten onto the spindle.
W,$$*(>%T.,(3"83
Charge battery before using this tool. Follow instructions included with battery charger.
U&(Z/"*4*%,89%U&(Z%@(*,%?*$%F/
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be hazardous objects, such
as utility lines or foreign objects, nearby
that will present a hazard while working.
4. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
5. Before beginning work, provide for sparks
and debris that will fly off the work surface.
To Next Page
Loading...
