Page 9For technical questions, please call 1-888-866-5797.Item 58379
SAFETYOPERATIONMAINTENANCE SETUP
Setting and Testing
1. Ensure accessory is correctly attached to tool.
2. Switch the Power Switch to the OFF position
then insert a fully charged Battery Pack,
making sure it clicks into place securely.
3. Switch the Power Switch to ON and run
the tool for at least 30 seconds.
4. If abnormal noise/vibration occurs or
the accessory slips, have the problem
corrected before further use.
General Instructions for Use
1. Make sure that the Power Switch is in the OFF
position, then insert a fully charged Battery
Pack making sure it clicks into place securely.
2. Hold the Tool with both hands and slide the
Power Switch to the ON position. The Work
Light will illuminate when the tool is switched
on and turn off when the tool is switched off.
WARNING! TO PREVENT SERIOUS INJURY: Do
not stare directly at the light beam. Never aim the
beam at any person or an object other than the
workpiece. Do not deliberately aim the beam at
personnel and ensure that it is not directed toward
the eye of a person for longer than 0.25 seconds.
3. Adjust the speed of the tool using the Speed Dial.
There are six speed settings from 1 (slowest)
to 6 (fastest). Determine the optimum speed
by testing on a scrap piece of material.
4. Do not allow contact between sand paper
or Blade and workpiece until the tool
is running at the intended speed.
5. Avoid contact with foreign objects
such as metal screws and nails when
sanding, scraping, or cutting.
Note: When sawing, always set the
Cutter Blade straight, at 90°, and guide
it through the cut without tilting.
6. Do not apply excessive pressure on the
Tool. Allow the Tool to do the work.
7. When finished, slide the Power Switch to
the OFF position. Allow the tool to stop
completely before setting it down.
8. To prevent accidents, turn off the tool and
remove the Battery Pack. Clean, then store
the tool indoors out of children’s reach.
To Next Page
Loading...
