Page 12 For technical questions, please call 1-888-866-5797. Item 70138
SAFETY OPERATION MAINTENANCESETUP
Cleaning Windows
a. Inspect caulking and/or glazing. Inspect trim.
DO NOT PRESSURE WASH WINDOWS IF
CAULKING/GLAZING/TRIM IS NOT INTACT.
b. If needed, apply detergent according
to manufacturer's instructions.
c. Set Nozzle to low-impact fan spray.
DO NOT USE HIGH-IMPACT SPRAY,
FORCE MAY BREAK GLASS.
d. Point Spray Gun at 45° angle to, and 4 feet
away from, window. Spray window.
Cleaning Wood
DO NOT CLEAN WOOD THAT IS
HOT OR IN DIRECT SUNLIGHT.
a. If needed, apply wood cleaning
detergent according to manufacturer's
instructions. For vertical surfaces,
apply detergent from bottom to top.
b. Scrub stained areas as needed.
c. Set Nozzle to low-impact fan spray.
d. Point Spray Gun at 45°. Spray surface,
working with the grain of the wood.
e. Let surface dry completely, then apply
stain or sealer, as needed, according
to manufacturer's instructions.
Cleaning Brick and Mortar
a. Inspect mortar, patching as needed. Let mortar
cure according to manufacturer's instructions.
b. Soak surface prior to applying detergent.
c. If needed, apply brick cleaning
detergent according to manufacturer's
instructions. For vertical surfaces,
apply detergent from bottom to top.
d. Scrub stained areas as needed.
e. Set Nozzle to low-impact fan spray.
TO PREVENT DAMAGE, ONLY
USE LOW-IMPACT SETTING.
f. Point Spray Gun at 45°. Spray surface.
g. Let surface dry completely, then
apply sealer, as needed, according to
manufacturer's instructions as needed.
8. When finished:
• Release Trigger, then Lock Trigger Safety Lock.
• Turn off Power Switch.
• Turn off water supply.
• Unplug the unit.
• Point Nozzle in safe direction, unlock
Trigger Safety Lock, press Trigger to
release all pressure, release Trigger,
then Lock Trigger Safety Lock.
• Disconnect water supply hose.
• Disconnect High-Pressure Hose from unit.
• Disconnect High-Pressure
Hose from Spray Gun.
9. IMPORTANT: CLEAN THE NOZZLES AFTER
EVERY USE TO MAINTAIN SPRAYING
POWER AND PREVENT PUMP DAMAGE.
• Remove Wand from Spray Gun.
• Pull back on the collar at the end of
the Wand and remove the Nozzle.
• Push Nozzle Tip Cleaner (included) into
tip to push out debris and buildup.
• Remove Nozzle Tip Cleaner and
back-flush water through Nozzle.
• Reattach Nozzle to Wand.
• Clean and store according to
User-Maintenance Instructions on page 13.
To Next Page
Loading...
