Page 12 For technical questions, please call 1-888-866-5797. Item 58871
SAFETY OPERATION MAINTENANCESETUP
Maintenance and Servicing Instructions
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• damaged cord/electrical wiring
• cracked or broken parts
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Periodically, wear ANSI‑approved
safety goggles and NIOSH‑approved
breathing protection and blow dust and grit out
of the motor vents using dry compressed air.
4. WARNING! TO PREVENT SERIOUS
INJURY: If the plug or the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Accessory Storage and Handling
1. Handle accessories carefully to prevent
dropping or bumping. Do not use grinding
wheels that have been dropped or bumped.
2. Store accessories in shelves, racks, boxes, or
drawers. Keep storage area dry and above
freezing. Any grinding wheels exposed to humidity
or freezing temperatures must not be used.
Sanding Belt Replacement
1. Loosen the two M5 x 12 Cap Screws securing
the Sanding Arm. Raise the Sanding Arm to the
vertical position and tighten the Cap Screws.
2. Remove the Sanding Belt Cover by loosening
the M5 x 20 Cap Screw securing the Cover.
M5x20
Cap
Screw
Sanding
Belt
Cover
Direction
of Rotation
Indicator
3. Push the Belt Tension Lever up to release
tension on the Sanding Belt.
4. Slide the old Sanding Belt off the
front and rear Drums.
Drum
Belt
Tension
Lever
Drum
Sanding
Belt
To Next Page
Loading...
