Bauer BG 30 - Lubricants

Maintenance/repair
○ Once after start-up
● Recurring
+ As needed
Symbol Maintenance inter-
val
Component
*) must be lubricated manually
● KDK shaft sealing ring (50) *
● KDK slide rails (51)
● Kelly guide slide rails (52) (if Kelly guide is present)*
● Kelly guide bearing (53) (if Kelly guide is present)*
● Rope swivel (54) *
Lubricants
Risk of causing damage to components!
Non-compliance with the following guidelines can cause damage to the components of the equip-
ment.
Δ
Only use prescribed lubricants.
Δ
Do not mix synthetic and petroleum based lubricants.
Δ
Do not mix zinc-free lubricants with lubricants that contain zinc.
Δ
Only use fresh lubricants.
Incorrect use of lubricants can lead to loss of warranty if damage occurs.
Lubricants table
The following table shows the relevant lubricants of the initial filling.
The specified quantities are guideline values. The specifications on the respective nameplates and
the level indicators of the individual components take priority. Alternative lubricants can be found in
the relevant "Lubricant selection lists" of this instruction manual.
Initial lubricant fill table
Component Quantity
[l]
Quantity
[gal]
Lubricant
type/speci-
fication
Viscosity
class/desig-
nation
Manufac-
turer
Manufac-
turer desig-
nation
Main winch 3.30 0.79 Gear oil/
CLP HC
ISO VG 220 CASTROL Alphasyn
EP 220
Auxiliary winch 2.50 0.66
Crawler drive 2 x 6.00 2 x 1.59
Swing mechanism
gear
8.00 2.11 Gear oil SAE 30 CAT CAT TDTO