Manual for BAUER RAINSTAR A1, A2
17
The exact setting of the regulation also depends on the PE-pipe diameter and it is different for PE-pipes of 40 -
58 mm.
By fixing the control rod one hole up, regulation will be reduced so that the retraction speed increases up to the
last layer.
By fixing the control rod one hole down, regulation will be increased so that the retraction speed is reduced up
to the last layer.
Do not set the speed unless the PE pipe has been rewound for half a winding
and/or unless traction has been applied.
Small water quantities
Big water quantities
Loosen the knurled nut (1) that fixes the control lever. Set the
retraction speed that can be read on the speedometer
(option), by means of the control lever (2). - To the left
"slower" and to the right "faster". Then fix the control lever (2)
again by means of the knurled nut (1).
IMPORTANT!
1
2
To Next Page
Loading...
