11
Connecting Appliances
1. Remove the plastic pull tab from the battery
compartment at the rear of the product to access
the internal batteries.
2. Plug the Power Meter into the mains socket.
3. Plug the appliance you wish to monitor into the
exposed socket of the power meter.
4. Switch the mains socket power switch to “ON”.
5. Use the connected appliance as normal - the
Power Meter will now monitor the energy used by
the appliance.
TIP: The internal batteries will allow you to set
the Power Meter functions before plugging into
the mains power.
Setting the Electricity Price
1. Press COST button for three seconds to enter
electricity price setting mode. When COST/KWh
on the LCD is displayed, use the UP button to set
the rate. Use the SET button to navigate between
the digits. When you have finished setting the rate,
press the COST button to save your settings.
2. The default value for electricity price field displays
as 1.00 COST/KWh.
Product Operation
To Next Page
Loading...
Need help?
General
