Baum 2020 - Page 12

TP10243-3 PAGE 12
The Easy-Mode is used for folds that require half of the sheet length or less going into the
foldplate. These folding applications normally operate with a 1.0 Inch sheet gap. If you are folding
half of the sheet length or more into the foldplate you must have a greater gap.
TURN THE EASY-PARAMETER ON/OFF
1. Press the Machine Setup button found in the top row.
2.
..
..
.Press the Sheet Gap
+ or - Buttons until P20 appears in the sheet gap display.
3. Press the Batch Count + Button until P25 appears in the sheet gap
display. You will now see the word “EASY” in the counter display
Batch Count + Button until P25 appears in the sheet gap display. You will now see the word “EASY”
in the counter display, see Figure E1.
Figure E1