CLEANING THE APPLIANCE
ALWAYS ALLOW THE APPLIANCE TO COOL DOWN
BEFORE CLEANING TO AVOID A BURN INJURY.
Do not use caustic or abrasive agents, coarse wire wool or hard
tools as these can damage the surface finishes.
Normally, wiping with a soft cloth dampened with hot detergent is
sufficient, but for stubborn marks the following is recommended:
VITREOUS ENAMEL PARTS
These parts can be cleaned using an oven cleaner. However contact
with other parts such as catalytic liners, door seal and heating
elements must be avoided as this may cause damage, also avoid
chloride-based products such as bleach.
INNER DOOR GLASS
Do not use any abrasive medium that could cause damage.
Remember that if the surface of the glass panel becomes scratched,
this could lead to a dangerous failure.
To facilitate cleaning, the door glass can be lifted out after
removing the fixing screws.
When refitting, make sure that the glass is correctly seated in the
door recess and the correct way round.
CLEANING THE OUTSIDE OF THE OVEN
Do not use caustic or abrasive agents, course wire wool or hard
tools as they can cause damage to the surface. Clean with warm
soapy water only. If your oven is stainless steel can use a stainless
steel polish.
Scratches caused by use of cleaning agents not recommended by
BAUMATIC LTD will invalidate the guarantee.
When cleaning the oven, the shelves and side racks can be
removed. Remove shelves by pulling forward. The side racks are held
in position by 2 hooks at the top and a securing nut at the bottom.
16
To remove first compress the lower wire and lift over the securing nut.
Then lift upwards to disengage the top securing hooks.
Care
must be taken when cleaning between the door glasses and
inside the inner frame as some of the edges maybe sharp due to
the manufacturing process.
To Next Page
Loading...
