25
o Check that the weight of the door is fully supported on the
hinges.
o Lower the door and raise the hinge clips, then return them away
from you and back to their starting positions.
o Check that the seal is in place then close the door. Make sure
that the inner face of the door meets and shuts against the seal
all around.
o Take care not to dislodge the hinge locking
system when removing the door, as the
hinge mechanism has a strong spring.
o Do not immerse the door in water at any
time.
INSTALLATION
The installation must be carried out by a suitably
qualified person, in accordance with the current
version of the following.
o UK Regulations and Safety Standards or their European
Norm Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Standards (issued by the Scottish Development
Department).
o IEE Wiring Regulations.
o Electricity At Work Regulations.
Before connecting the appliance, make sure that the supply voltage
marked on the rating plate corresponds with your mains supply
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 20 A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
an easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located in
its housing.
To Next Page
Loading...