Baumatic BC190.2TCSS - Minimum Flow Adjustment for the Oven and Grill Burners

35
o Loosen the burner screw (V) and then carefully pull the burner
away from its support. IMPORTANT: Care must be taken to
ensure that no damage is caused to the ignition plug or
the thermocouple.
o Unscrew the injector using a 10 mm spanner and replace it with
the stipulated injector for the new gas supply (see table below).
Gas
consumption
Power
(kW)
Burner Types
of gas
Pressure
(mbar)
Injector
Marking
(1/100
mm)
g/h l/h Max. Min.
Natural
(G20)
20 150 - 429
Butane
(G30)
28 95-X 218 -
Oven
Propane
(G31)
37 95-X 214 -
4.50 2.00
Natural
(G20)
20 115 - 191
Butane
(G30)
28 68 145 -
Grill
Propane
(G31)
37 68 143 -
2.00 N/A
IMPORTANT: You must change the oven and grill injectors.
IMPORTANT: After changing the injectors YOU MUST follow the
minimum flow adjustment section below.
Minimum flow adjustment for the oven and grill burners
All work must be carried out by a GASSAFE
registered engineer.
o Light the burner and set the knob at the minimum position.
o Remove the knob from the
tap and place a small bladed
screwdriver in the screw
indicated in the picture
opposite.
o Unscrew the adjusting screw,
in order to increase the gas
flow or tighten the adjusting
screw to decrease the gas
flow.