The 3 in 1 wash program
Make sure that the water softener has been filled with salt
and that the water softener has been set to its lowest
setting.
Make sure that the rinse aid dispenser has been set to an
appropriate level.
THIS WASH PROGRAM MUST BE SELECTED IF YOU ARE USING 3
IN 1 DETERGENT. IF YOU USE ANY OTHER WASH PROGRAM
WITH 3 IN 1 TABLETS, THEN YOU MAY GET POOR WASH
RESULTS.
o Hang the 3 in 1 tablet container on the underneath of the upper
basket, in the position shown on the diagram.
o Check that the 3 in 1 tablet container is not going to foul the
upper spray arm, by rotating the spray arm around slowly. If it
does hit the 3 in 1 tablet container, you should move it.
o Put a 3 in 1 tablet inside the 3 in 1 tablet container. Load the
appliance as normal and select the 3 in 1 wash program.
If your wash results are poor, then we would recommend
that you use a dishwasher detergent that doesn’t have
rinse aid and salt included in the tablet. The water softener
should then be adjusted to an appropriate level for the
hardness of the water in your area.
25
To Next Page
Loading...
Need help?
General
