Cleaning the spray arms
The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
o To remove the spray arm,
unscrew the nut and take out the
washer that sits on top of the
spray arm.
o Gently pull to remove the spray
arm.
o Wash the spray arm in warm,
soapy water and use a soft brush
to clean the jets.
o Rinse the spray arm thoroughly
and then reassemble the spray
arm back in its original position.
Cleaning the control panel
IMPORTANT: Do not use any abrasive cleaner or household polish on
either the control panel or operating parts.
o Wipe over the control panel using a brand new damp cloth with
warm water.
Cleaning the door
o To clean the edge around the outside of the door, you should use
a soft, damp cloth only.
o To prevent water from penetrating the door lock or electrical
components, DO NOT use a spray cleaner of any kind.
o DO NOT use any abrasive cleaner or scouring pads on the inner
or outer surfaces, as they may cause damage to them.
28
To Next Page
Loading...
