30
o Ensure that the rear panel of the furniture housing unit has been
is a hole to feed the electrical cable
through. These steps must be done before commencing the rest
r the ventilation cut
shown in the diagram MUST be present, otherwise the
air intake points.
MPORTANT: NO OTHER METHODS OF BUILDING UNDER THE
The rear wall of the housing unit MUST be removed to allow
removed.
o You must ensure that there
of the installation process.
o This oven may be installed without any additional ventilation cut
outs being made in the housing unit. Howeve
microwave oven may not function correctly.
o Do not cover the ventilation slots or
Built under installation requirements
I
MICROWAVE ARE SANCTIONED BY BAUMATIC.
o
there to be the correct amount of ventilation.
To Next Page
Loading...
