26
T +18 to +43 degrees centigrade
o Positioning the appliance requires two people in order to avoid
injuries or damage to the appliance.
o Keep a minimum of 90 mm between your refrigerator and the
back wall. There should also be a gap of 20 mm either side. If
there is insufficient space this can create the sound of vibration,
weakening of the refrigerator’s power and a waste of electricity.
o The appliance should never be placed upside down or carried in a
horizontal position.
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not possible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o Place the appliance flatly and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, which
can be used to level the appliance.
o If the front of the appliance is positioned slightly higher than the
rear, the door can be opened and closed more easily.
o If your refrigerator tilts down to the
left, turn the left adjusting leg until
the appliance is level.
o If your refrigerator tilts down to the
right, turn the right adjusting leg until
the appliance is level.
o If you are placing another cooling appliance next door to this
product, then there must be a gap of at least 2 cm between the
appliances. This will help to prevent condensation from forming.
o Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury.
To Next Page
Loading...
