15
3) Use a screwdriver to take
out the two screws that go
through the fixing point and
then lower the carbon filter
over the motor casing hole.
o The corner with the
diagonal cut-out on it,
must be positioned
against the fixing point
(as shown in the above
picture).
o Retighten the two screws through the fixing point, into the
carbon filter. These screws must be fully tightened.
4) After fitting the
carbon filter, the
underneath of the
cooker hood
should appear as
in the drawing
opposite.
o Refit the grease filters.
o The carbon filters should be replaced approximately every three
months, if they show signs of damage, or if you start to notice
that cooking smells are entering the kitchen through the upper
vents.
To Next Page
Loading...
