Baumatic BW18 - Troubleshooting

Your Baumatic BW18 Wine Cooler
15
Troubleshooting – If you are having a problem with your Wine
Cooler, please check it against the table below before calling for service.
Symptoms Possible Cause Solutions
- No power supply
- Make sure it’s plugged
in or check circuit
breaker.
- Low voltage - Ensure normal voltage.
Your Wine Cooler is Not
Working
-Fuse Broken - Change fuse.
- Your cooler is too
close to another heat
source
- Keep the wine cooler
away from direct sunlight
or other heat sources.
- Gasket seals are dirty - Clean the gasket seals.
- Poor Ventilation
- Ensure that the wine
cooler is well-ventilated
and keep things away
from the fans.
- Fan is not working
- Make sure the plug is
connected. Alternatively,
you may need to have the
fan changed.
- The door has been
opened too frequently,
left open too long, or
was not closed tightly
- Close the door tightly
and leave shut for a
while. Do not open the
door too frequently.
Not Cold Enough
- Your Wine Cooler’s
running temperature
may be too high
- Check the temperature
adjustor & set to a lower
(cooler) temperature.
- Too low temp. setting - Raise temp. setting.
Too Cold
- Ambient Temperature
is too low
- Turn heating on in room
or move your Wine Cooler
to a warmer place.
Inside light flashes
- Set temperature is
higher than inside
temperature
- Adjust the temperature
adjustor.
Frost showing
- Too much humidity or
too low inside
temperature
- Unplug to defrost; plug
in again after the ice
thaws.