What to do if there is water in the detergent dispenser of my Baumatic Washer/Dryer?
If you notice water in the detergent dispenser of your Baumatic Washer/Dryer, you may need to clean the detergent drawer, especially if it is full of water.
How to improve poor spin results in my Baumatic BWD12.1?
To address poor spin results with your Baumatic Washer/Dryer, clean the drain pump. For instructions, consult the 'Cleaning the drain pump filter' section.
Why does my Baumatic BWD12.1 vibrate during the spin cycle?
If your Baumatic Washer/Dryer vibrates during the spin cycle, first ensure that the transport locking devices have been removed according to the installation instructions. Also, check that the appliance is installed on a flat and level floor. Make sure all four feet are resting firmly on the floor by pressing down on each corner to ensure stability. If it remains unstable, refer to the section on 'Positioning and leveling the appliance'.
How to fix water under my Baumatic BWD12.1?
If you find water under your Baumatic Washer/Dryer, start by tightening the drain pump filter. Then, check the drain and inlet hose to ensure they are fully tightened.
Why does my Baumatic BWD12.1 have poor wash results?
If you're experiencing poor wash results with your Baumatic Washer/Dryer, consider the following: ensure you are adding enough detergent and using the correct type of detergent for your load. Pre-treat any stains before washing. Finally, verify that you have selected the appropriate wash program and temperature for the items you are washing.
Why can I still see foam after the final rinse in my Baumatic Washer/Dryer?
Modern detergents can cause foam to remain after the final rinse in your Baumatic Washer/Dryer. This does not necessarily indicate that the washing process was inadequate.
General| Brand | Baumatic |
|---|---|
| Model | BWD12.1 |
| Category | Washer/Dryer |
| Language | English |
To Next Page
