9 Once levelled correctly, you should tighten the
lock nut back up on each of the washing
machine feet using a spanner.
IMPORTANT: When the washing machine is positioned in the location
where it will be used. Make sure that all four feet are resting firmly on
the floor, by pressing down on each corner and checking that the
appliance stands still.
Connecting to the mains water supply
9 The water inlet hose will be inside the drum of your washing
machine, when you receive the appliance.
33
9 Connect and fully tighten the inlet hose to
the threaded inlet valve that is located at
the rear of the washing machine. You
should connect the end with the right
angle connector on it to the back of your
appliance.
9 Connect the other end of the inlet hose to your mains
water supply
To Next Page
Loading...
