o
Remove the light cover by turning it anti-clockwise.
o
Unscrew the bulb clockwise and remove it from its holder.
o
Replace the bulb with a 25 W/300°C, screw type pygmy.
o
Do not use any other type of bulb.
o
Place the lamp cover back into position.
Removing the oven door for cleaning
To facilitate the cleaning of the inside of the oven and the outer frame
of the oven, the door can be removed as follows:-
o
Open the oven door fully.
o
The hinges (A) have two movable bolts
on them (B).
o
If you raise both of the movable bolts
(B), then the hinges (A) are released
from the oven housing.
o
You should grip the sides of the door at the centre and then
incline it slightly towards the oven cavity and then pull it gently
away from the oven cavity. WARNING- Care should be taken
as the inner edges of the door may be sharp.
o
IMPORTANT: You should make sure that the door is supported
at all times and that you place the door on some padded
material whilst cleaning it.
o
The oven door and door glass should only be cleaned using a
damp cloth and a small amount of detergent. The cloth MUST
NOT have come into contact with any form of cleaning product
or chemical previously.
o
To refit the door you should slide the hinges back into their slots
and open the door fully.
o
IMPORTANT: The movable bolts (B) must be closed back into
their original positions before closing the door.
o
Take care not to dislodge the hinge
locking system when removing the door,
To Next Page
Loading...
