16
o To dispense steam, press the steam boiler dispensing button
(32).
NOTE: Steam will dispense from the pipe for boiling water and
steam (17).
o To stop steam from dispensing, press the same button again.
¾ The noise generated during this operation is perfectly
normal. This is caused by the activation of the high
pressure pump during this operation.
¾ It is also quiet normal for a certain amount of water to
drip into the drip tray after water has been dispensed.
o WARNING: During this operation,
extreme caution should be
exercised, as the dispensing pipe will
get hot.
o When releasing steam, avoid
directing the steam towards your
person. There is a danger of
scalding.
o Always use a container or a mug
underneath the dispensing pipe
whilst dispensing steam.
3) Dispensing boiling water through the steam boiler
o Follow the instructions on filling the water reservoir (pages 11 –
14) as stated previously and proceed as follows:-
o Press the steam boiler activation button (31) to allow the boilers
to heat up. During this process, the steam boiler status indicator
(25) will flash.
o Whilst the steam boiler is heating up, it is normal to get a small
amount of water dripping from the pipe (17).
o When the boilers have reached their operating temperature, the
steam boiler status indicator (25) will stop flashing and remain
steady.
o To dispense boiling water, press the boiling water dispensing
button (33).
To Next Page
Loading...