Baumr-AG BPR-800E - Electronic Brake System; Charger

BPR-800E Power Barrow
E&OE
© 2023 Baumr-AG
12
Electronic Brake System
This wheelbarrow is equipped with an electronic brake EBS/BAS.
BAS ON
The EBS will work only when:

Button on the battery box is ‘I’ (ON).

Thumb switch #1 is at its original position, no acceleration.
EBS ON
The EBS will work only when:

Button on the battery box is ‘I’ (ON).

Brake switch #3 at ‘I’ position.
NOTE:
•
When the EBS is turned ON, the wheelbarrow will activate the brake to stop completely. Even if you press
the thumb switch, the wheelbarrow won’t move.
•
When the BAS is turned ON, the wheelbarrow will stand still on the flat ground, it may run slowly on slopes.
•
The BAS won’t drain the battery power. Instead, the EBS will be drained. So, it’s recommended to use BAS
sparingly.
•
The two above brakes will provide convenience and safety while the wheelbarrow is on a slope or dumping
debris.
Charger
The charger is integrated into the battery system.
Charging the battery:
1. Connect the charger to the power supply and the charger plug.
2. Charge the battery.
3. Once the battery is fully charged (indication on the charger), the charger can be removed.
4. LED - indicator on the control element: Voltage-display on battery box indicates the status of the battery.
Voltage display shows 42V
Battery capacity 100%
Voltage display shows 36V
Battery capacity 50%
Voltage display shows < 30V
Please charge the battery (little capacity left)
1: Voltage display switch
2: Voltage display
3: Recharge port