Maintenance
ATTENTION: Surface corrosion will occur on metal surfaces over time and the rate of oxidation depends
on factors such as proximity to the ocean and humidity or condensation of water vapour on metal
surfaces. To mitigate this, WD40 can be used to remove surface corrosion then, when applied
periodically, it will prevent rust from forming.
Unplug battery before all maintenance and settings! Serious injury due to unintentional or automatic
activation of the machine!
•
The machine does not require extensive maintenance. If malfunctions and defects occur, contact a qualified
technician or an authorised service centre.
•
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a prerequisite for
a safe working environment.
•
Repair jobs should only be performed by trained professionals only!
•
Regularly check the condition of the security stickers. Replace them if required.
•
Regularly check the condition of the machine.
•
Store the machine in a closed, dry location.
•
After each work, check the cables (tight fit, check for damages).
Cleaning
•
The usage of certain solutions containing ingredients that could damage metal surfaces as well as the use of
scrubbing agents will damage the machine surface!
•
Clean the machine surface with a damp cloth soaked in a mild solution.
•
Never use running water or a high-pressure cleaner to clean the machine.
•
Clean the outer parts with a damp sponge.
•
Never clean the electronic parts with water!
•
Check the machine and remove the deposits and / or residues with a soft brush.
Storage
•
Clean thoroughly all components before storage.
•
Store all components separately in a dry area at not less than -10°C.
•
Charge the battery fully before storing.
•
Charge the battery at least once a month for extended storage periods.
To Next Page
Loading...