Assembly
Mono Power Unit BUM 62, 63, 64 17
Baumüller Nürnberg GmbH 5.94005.12
4 ASSEMBLY
WARNING
The user is responsible for the assembly of the converter power unit, the motor and the other compo-
nents according to applicable safety standards (e.g. DIN, VDE) and all other relevant national or local
regulations regarding conductor dimensions and fusing, grounding, circuit breakers, overcurrent pro
-
tection etc.
A space must be left above and below the units, and sufficient cool air and air circulation must be pro-
vided.
Sheets of plastic on the devices that cover the equipment connection act as additional guards pre-
venting accidental contact at commissioning and in the case of casual use of control elements located
close to the equipment (DIN VDE 0106 Part 100, Accident Prevention Regulation VBG4 "Electrical
Systems and Equipment").
Pollution degree 3 and 4 according to EN 50178/VDE0160/4.98 Section. 5.2.15.2 must be avoided.
The units are suitable for the installation in closed operating rooms. (VDE 0558 Part 1a, Section
5.4.3.2.1 and 5.4.3.2.2
To Next Page
Loading...
