Baur DPA 75 User Manual

0-1
Fully Automatic
Insulating Oil Tester DPA 75
Designed for the fully automatic measuring of the
electric breakdown strength of insulants
Operating Instruction
12/98
Ident no. 822-073
BAUR Prüf- und Messtechnik GmbH
Raiffeisenstrasse 8, A-6832 Sulz / Austria
Tel +43 / 55 22 / 49 41-0
Fax +43 / 55 22 / 49 4 13
e-mail: headoffice@baur.at
internet: http://www.baur.at

Baur DPA 75 Specifications

General

Frequency	50/60 Hz
Diagnostics	Automatic detection
Display	LCD
Units	bar
Operating Temperature	0°C to 50°C

Summary

Essential Safety Precautions

General Safety Guidelines

Provides essential safety warnings and precautions for operating the Insulating Oil Tester DPA 75.

Product Overview and Specifications

Test Cycle Process

Step-by-step guide for performing a test cycle with the DPA 75 unit.

Control Panel and Operation Interface

Receiving, Setup, and Initial Operation

Initial Startup and Configuration

Steps for powering on the unit, performing self-tests, and configuring basic settings like language and time.

Pre-Test Preparations and Procedures

Electrode Spacing and Test Vessel Filling

Detailed steps for setting electrode spacing and properly filling the test vessel with liquid.

Executing the DPA Test

Instructions on initiating and running the DPA test, including calibrator connection.

Performing Standard and Custom Tests

Standard Test Execution and Results

Procedure for performing standard tests, selecting standards, and interpreting results.

Custom Test Cycle Management

Single Test Operation and Results