Reset Button
If the Red Flame Failure Light ( ) is ON or
flashing, press the Reset button until the red light
goes OFF. If this occurs frequently a fault is indicated,
you should contact your installer.
1.0 Quick Reference Guide
3
© Baxi Heating UK Limited 2005
Low
High
ON
Reset
Low
High
Domestic Hot Water Temperature Control
Turn the Domestic Hot Water Temperature Control
Knob clockwise to increase or anticlockwise to
decrease the temperature. Range 45 - 55° C.
Central Heating Temperature Control
Turn the Central Heating Temperature Control Knob
clockwise to increase or anticlockwise to decrease
the boiler flow temperature.
Low
High
ON
Reset
Low
High
ON
Low
High
Flame Failure
(Red Light)
Burner On
(Green Light)
Mains On
(Green Light)
Central Heating
Control Knob
(No OFF Position)
Reset Button
If Flame Failure Light is ON press the Reset Button. If Flame Failure occurs
frequently consult your Installer.
This indicates that the Burner has fired up and is heating your system.
This indicates that there is electricity to the Boiler.
Turn the Central Heating Control Knob clockwise to increase or anticlockwise
to decrease the boiler flow temperature.
The Reset Button should extinguish the Flame Failure Light and allow
normal operation to commence.
Low
High
Domestic Hot Water
Control Knob
(No OFF Position)
Turn the Domestic Hot Water Control Knob clockwise to increase or
anticlockwise to decrease the temperature.
Domestic Hot Water
(Green Light)
This indicates that the Burner has fired up and heating your water.
Key to Controls
To Next Page
Loading...
