Baxi LUNA HT 330 Setup

Setting Parameters:
The editable parameters are those between 504 and 652. Proceed as follows to access
these parameters:
1. Simultaneously press keys 1 and 4 on the QAA73 controller for
approximately 3 seconds. The message “Initializing BMU parameters”
appears on the display.
2. Simultaneously press keys 1 and 2 for approximately 3 seconds. Parameter
504 will appear on the display.
3. Press key 1 or 2 to scroll through the list of parameters.
4. To change the value of a selected parameter, press key 3 or 4 to decrease or
increase the value respectively.
5. Press key 5 to enter the new values and exit programming of the boiler.
BAXI LUNA HT 1.650 SETUP NATURAL GAS
Luna HT 1.650 Setup Natural Gas

Baxi LUNA HT 330 Specifications

General

Mounting	Wall-mounted
Fuel Type	Natural Gas / LPG
NOx Class	5
Max working pressure	3 bar
Electrical supply	230 V / 50 Hz
Ignition	Electronic
Expansion Vessel	10 liters
Water pressure	Min 0.5 bar, Max 3 bar
Flue system	Sealed system
Flow rate at ΔT 35°C	14.3 l/min