13
Groups of days
On 1 - Off 1 On 2 - Off 2 On 3 - Off 3
Mon-Sun
06:00 - 08:00 11:00 - 13:00 17:00 - 23:00
Mon-Fri
06:00 - 08:00 17:00 - 23:00
Sat-Sun
Individual days
On 1 - Off 1 On 2 - Off 2 On 3 - Off 3
Monday-Tuesday-
Wednesday
Thursday-Friday
06:00 - 08:00 11:00 - 13:00 17:00 - 23:00
Preset programs
Day interval
Summary table
Program line 514 (heating) - 574 (DHW)
Preset programs
06:00 - 23:00
Prog. lines 501 502 503 504 505 506 (heating) - 561 562 563 564 565 566 (DHW)
Preset
programs
To facilitate programming, the existing programs may be copied to the other days of the week. The procedure
is as follows:
Copying a program to another day
After programming the hourly range for a set day, it may be copied to one or more days of the week.
The parameter in brackets « ( ) » refers to the hourly programing in DHW
• From program line 514 (574) (if one of the 3 preset hourly ranges is used) or from the program line 501(561) (if the
manual programming was executed), turn the button to the right to the program line 515 (575).
• The display shows Copy?.
• B Copy to : the day of the week flashes.
• B To scroll through the days of the week, choose the day where the program is to be copied then B to confirm.
• Repeat the point above if you want to copy the same daily program to other days.
• C to return to the previous menu.
Restoring the original programming (default)
The weekly programming may be deleted and the comfort heating activated (the value which will be programmed is 00-24,
identical for all the days of the week).
• C B CC1 hourly program B the program line 500 (CC1 hourly program) or 560
(Hourly program 4 / DHW).
• B a position anti-clockwise,the program line 516 (Default values) for the heating and program line 576 for the
DHW.
• B a position until Yes is displayed, B to confirm.
• C to return to the previous menu.
When the main menu is displayed once the procedure is complete, you will note that the daily programming
bar changes. The heating is still active for 24 hours. To reprogram the boiler, you must repeat the procedure
described in chapter 6.
To Next Page
Loading...
