EasyManua.ls Logo

baxter 64416 - Troubleshooting Guide; Decreased Output Issues; Severe Air Leakage; Housing Heating and Moisture Issues

baxter 64416
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 13?)+('-71;%7/:(K*-&'%);&L(2:-/&-(7/::(#MNNNMN!!MOPQP4Item 64416
BC?9DRST9>CDFSHGCFHD9HCHU9 B9DIT
D+)*.:-&1))'%;6
T+).:-8 T)&&%.:-(U/*&-& J%\-:A(B):*'%);&
Decreased output� 1� Not enough air pressure�
2� Low air flow
3� Obstructed Trigger
4� Blocked air inlet screen
(if equipped)�
5� Air leaking from loose housing�
6� Mechanism contaminated�
7� Clogged Silencer Filter
1� Ensure the air hose is the proper size� Check for loose
connections and make sure that air supply is providing
enough air flow (CFM) at required pressure (PSI) to the
tool's air inlet� Y)(;)'(-]7--<(8/]%8*8(/%+(2+-&&*+-4
2� Adjust the Regulator Value on the Sander
3� Clean around Trigger to ensure free movement�
4� Clean air inlet screen of buildup�
5� Make sure housing is properly assembled and tight�
6� Have qualified technician
clean and lubricate mechanism� Install in-line filter
in air supply as stated in Setup: Air Supply
7� Remove and wash/replace the Sander’s filter
Severe air leakage�
(Slight air leakage
is normal,
especially on
older tools�)
1� Cross-threaded housing
components�
2� Loose housing�
3� Damaged valve or housing�
4� Dirty, worn or damaged valve�
1� Check for incorrect alignment and uneven gaps�
If cross-threaded, disassemble and
replace damaged parts before use�
2� Tighten housing assembly
If housing cannot tighten properly,
internal parts may be misaligned� Technician needs
to disassemble tool, align parts and reassemble�
3� Replace damaged components�
4� Clean or replace valve assembly
Housing heats
during use�
Worn parts� Have qualified technician inspect internal
mechanism and replace parts as needed�
Moisture is
blowing out of the
Sander’s exhaust�
There is water in the air
compressor’s tank�
Drain the air compressor’s tank (see air
compressor manual for instructions)� Lubricate
the Sander with oil and run it until moisture no
longer comes out of the exhaust� Lubricate
the tool again and run for 1-2 minutes�
?)::),(/::(&/5-'A(2+-7/*'%);&(,1-;-^-+(<%/6;)&%;6()+(&-+^%7%;6('1-(')):4(((
Y%&7);;-7'(/%+(&*22:A(.-5)+-(&-+^%7-4