Page 4 ?)+('-71;%7/:(K*-&'%);&L(2:-/&-(7/::(#MNNNMN!!MOPQP4 Item 64416
BC?9DR ST9>CDFSH GCFHD9HCHU9B9DIT
B-+^%7-
1� Tool service must be performed only
by qualified repair personnel.
2� V1-;(&-+^%7%;6(/(')):L(*&-();:A(%<-;'%7/:(
+-2:/7-8-;'(2/+'&4((I&-();:A(/*'1)+%`-<(2/+'&4
C%+(B)*+7-
1� H-^-+(7);;-7'(')(/;(/%+(&)*+7-('1/'(
%&(7/2/.:-()5(-]7--<%;6(abb(2&%4
Over pressurizing the tool may cause
bursting, abnormal operation,
breakage of the tool or serious injury
to persons� Use only clean, dry, regulated
compressed air at the rated pressure or within the
rated pressure range as marked on the tool�
Always verify prior to using the tool that the air
source has been adjusted to the rated air pressure
or within the rated air-pressure range�
2� Never use oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source
for the tool. Such gases are capable of
explosion and serious injury to persons�
(BC$9(DE9B9(FHBD>IUDFSHB4
BA8.):&(/;<(B2-7%5%7(B/5-'A(F;&'+*7'%);&
BA8.):(Y-5%;%'%);&
BA8.): T+)2-+'A()+(&'/'-8-;'
;
)
No-load speed
44438%;
Revolutions or reciprocation per minute
TBF
Pounds per square inch of pressure
5'M:.
Foot-pounds of torque
XTG
Blows per minute
U?G
Cubic Feet per Minute flow
BU?G
Cubic Feet per Minute flow
at standard conditions
BA8.): T+)2-+'A()+(&'/'-8-;'
HTD
National pipe thread, tapered
HTB
National pipe thread, straight
WARNING marking
concerning Risk of Eye Injury�
Wear ANSI-approved eye protection�
WARNING marking concerning Risk of
Hearing Loss� Wear hearing protection�
WARNING marking concerning
Risk of Respiratory Injury� Wear
NIOSH-approved dust mask/respirator�
WARNING marking concerning
Risk of Explosion�
To Next Page
Loading...