10
Assembly Instructions
13. Hook the ladder (N) securely over the top of the upper ladder side rail (G), between the front guardrail post
(K) and the upper footboard (D) in the opening provided. Make sure that the bottom threaded inserts align
with the drilled holes on lower ladder side rail (E) properly.
ONLY USE THE LADDER IN THIS LOCATION. IT MUST BE SECURED WITH TWO SCREWS
TO HELP PREVENT ACCIDENTS OR INJURY FROM THE LADDER DISLODGING. MAKE
SURE YOU INSTALL THE LADDER AGAINST THE FRONT GUARDRAIL POST.
14. Insert two bolts (CC) through the pre-drilled holes on the lower ladder side rail (E) and securely screw into
the threaded inserts on the bottom of the ladder (N). Screw the two hooks, pre-attached on the top of the
ladder (N), to the upper ladder side rail (G) with two screws (FF).
15. Lay out the lower mattress support slats (L) between the lower side rails (E and F). Make sure that every
slot has a slat. Insert two screws (EE) through the countersunk holes in each slat and securely
screw into place.
E
G
N
N
G
N
G
FF
E
N
CC
EE
EE
E
L
F
F
L
E
To Next Page
Loading...
