Bazooka BASE TUBE - Pre-installation Precautions and Disassembly; Pre-installation Precautions; Battery Disconnect

TOYOTA FJ CRUISER
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
• Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
• Safety (eye protection, rechecking torque procedure, etc.).
• Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
• Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
1. Pre-installation Precautions
(a) Use Seat & Floor Protectors and Fender
Covers/Blankets to avoid damage to
surfaces. Operator Safety Warning (if
applicable.)
2. Battery Disconnect
(a) NOTE: Be sure to open the rear hatch,
PRIOR to disconnecting the battery.
(b) Remove the NEGATIVE (-) battery
terminal using a 10mm socket before any
disassembly starts. (Fig. 2-1).
3. Disassemble Center Rear Storage Area
(a) Remove Cargo Net Cleats using 10mm
Socket. Place in a safe location.
(b) Remove Side Trim Cover, Quarter Trim
Pocket, Quarter Trim Pocket Tray. (Fig.
3-2)
Fig 2-1
Fig 3-2
STOP
STOP
STOP
Southeast Toyota Distributors, LLC Page 2 of 9