BASS TUBE (BAZOOKA
®
)
4. Mount L-Brackets
(a) On wheel well, slide L-brackets under
side garnish ensuring no wires are
pinched. Insert Ground ring between
front L-bracket and vehicle. DO NOT
TIGHTEN AT THIS POINT! (Fig. 4-1)
NOTE: It may be necessary to unsnap
factory harness clip to align rear L-bracket.
5. Route Wire Harness
(a) Plug harness in at point shown. (Fig. 5-1)
(b) Route Wire harness as shown. (Fig. 5-2)
(c) Secure Wire harness at regular intervals
using 4” wire ties.
Fig. 4-1
Fig 5-1
(1) Fig. 5-2
Southeast Toyota Distributors, LLC Page 3 of 9
To Next Page
