Bazooka BASE TUBE - Page 4

BASS TUBE (BAZOOKA
®
)
6. Install Main Plate
(a) Using the Cargo Cleats and the M6 x
35mm, loosely mount the top of the main
plate. DO NOT TIGHTEN AT THIS
POINT! See Fig 6-1.
(b) Route wiring harness through slot in
Main plate as shown. (Fig 6-2)
(c) Using two M6 x 20mm bolts and a
washer, bolt the lower points of the main
plate to the L-Brackets. DO NOT
TIGHTEN AT THIS POINT! (Fig. 6-3)
7. Tighten All Bolts
(a) Tighten bottom L-bracket bolts.
(b) Tighten Cargo cleat bolts.
(c) Tighten Main Plate bolts to L-brackets.
Fig 6-1
Fig 6-2
Fig 6-3
Southeast Toyota Distributors, LLC Page 4 of 9