BBC Bircher RFGate 2.2.S - Start-up and Programming; System Start-up Checklist; Pairing Transmitter with Receiver; Clearing Transmitter-Receiver Pairings

3
1
2
ON
1 2
+
+
2032
2032
ON
1 2
+
2032
1 2
ON
1 2 3 4
ON
i
ON
OK?
1 2 3 4
ON
2x
2x
i
i
6.1. RFGate 2.1, pairing transmitter with receiver
5 Start-up
6 Programming
2.
On the
transmitter
On
the
receiver
Press and
release button
Beep Wait 2
beeps
10 sec.
1.
On the receiver
Press
button
Beep
> 1.5 sec.
LED
lights up
6.
Transmitter:
install
Release
button
4.
Transmitter:
insert
batteries
1.
Check DIP
switch settings
5.
Programming (Chapter 6.1):
pair transmitter with receiver
Transmitters and receivers (also
among each others) must be at
least 0.5 m apart.
Observe
order
6.2 Clear pairings
6.3 Memory full
Press
button and hold
Keep pressed
the button
Short beeps Beep WaitRelease
button
10 sec.
> 1.5 sec. > 3 sec.
2
beeps
Code saved
LED goes out
Please observe the torque when
fastening the cover:
Max. 45 N cm
7.
Transmitter:
wire
3.
Turn on power
supply
2.
Install and wire
receiver
8.
System test of safety
edge on gate
On
the
receiver
All pairings
deleted
Beep
Beep Beep
Beep
Beep 10 sec.
Beep Beep Beep
Beep
Transmitters and receivers (also among
each others) must be at least 0.5 m apart.