REAR PANEL
BATTERY COMPARTMENT
Use a standard 9Volt battery.
Battery life is about 15 hours.
Unplugging the input to the DI-
100x will turn the unit off and
conserve battery life.
POWER SUPPLY
CONNECTOR
Connect the included
9VDC power supply
here.
XLR OUTPUT CONNECTOR
The XLR output of the DI-100x is
balanced. The XLR output is used for
running from the DI-100x directly to
the input of a mixing console.
Note: The XLR and 1/4” output
connectors can be used simultaneously.
XLR Pin configuration:
Pin 1 = Ground, Pin2 = Positive and
Pin3 = Negative.
1/4” UN-BALANCED OUTPUT CONNECTOR
The 1/4” output connector of the DI-100x is
impedance-balanced.
Note: The XLR and 1/4” output connectors can be
used simultaneously.
GROUND LIFT SWITCH
When in the “lift” position Pin
1 of the balanced XLR output
(ground) is disconnected.
6
To Next Page
Loading...
