USER MANUAL / ENGLISH
10
Turn off the system, open the zipper on the airbag and unhook the 5 hooks.
Open the backpack and the strap pocket. Detach the trigger handle.
Remove the trigger handle through the opening between the shoulder
strap and the airbag compartment.
Remove the compressor through the side of the airbag compartment
11 INSTRUCTIONS
REGULAR CHECKS
Your Float E2 Airbag system requires no maintenance, but the following points must be observed:
1- Perform practice deployment of airbag at least once a year, prior to a new season and after the backpack has been exposed to moisture.
2- Ensure that the airbag and components are completely dry before packing the airbag away.
3- Prior to every tour, check all the points described in this user manual and inspect the condition of the system’s safety straps and fastenings.
12 MAINTENANCE
POST-AVALANCHE CHECK
Every use of the Float E2 Airbag system can negatively affect the material. Often the damage is not visible with the naked eye. After use in an
avalanche, you must contact your nearest BCA or ALPRIDE service center for inspection of the Float E2 Airbag system. Until you are able to send
back the Float E2 Airbag system, the following points must be checked.
• Check the airbag visually for punctures.
• Check the airbag fastening straps for tears.
• Check the shoulder, waist and chest straps as well as the seams for tears.
• Check all buckles (adjustment buckles at the shoulder straps, waist and chest strap).
• Check buckles as well as leg straps for tears and deformation.
HOW TO REMOVE THE DETACHABLE AIRBAG SYSTEM
To Next Page
Loading...
