BASIC PERFORMING METHOD
BATTERY INSTALLATION
• Open battery cover on the back of the keyboard and install six AA batteries. Load batteries with the correct
polarity and replace battery cover.
• Empty batteries must be replaced immediately because battery loss may decrease volume or distort timbre.
• Remove batteries if keyboard is unused for an extended period of time.
USING POWER ADAPTOR
• Do not use any other power supply adaptor other than the one supplied with this unit. Connect one side to the
power supply socket on the back-panel and the other side to an outlet.
• Note: The input voltage should be compatible with the outlet power.
AUDIO OUTPUT / HEADPHONE JACK
• Play keyboard through external audio device, speakers, or headphones. Turn o keyboard before connecting
external speakers or audio devices to keyboard. Connect these devices via the “PHONES/OUTPUT” port on the
back of the keyboard.
• Insert headphones (not included) into the “PHONES/OUTPUT” jack on the back of the instrument. The speaker
will automatically turn o when headphones are in use.
• WARNING: Hearing loss can occur if headphones are used at too high of a volume.
MIC INPUT
• You can connect a microphone (not included) via the “MIC” port to use with the keyboard.
PERFORMANCE PREPARATION
6 |
Press “POWER ON/OFF” to turn on keyboard. The LED display will light up and show the preset tempo: “120.”
MASTER VOLUME ADJUSTMENT
• Press “MASTER VOL +” or “MASTER VOL - " to increase or decrease the overall volume.
• Press both buttons at the same time to reset the volume to default.
• Master volume can also control the accompaniment volume.
ACCOMPANIMENT VOLUME ADJUSTMENT
• Press “ACCOM VOL +” or “ACCOM VOL -“ to increase or decrease the accompaniment volume.
• Press “ACCOM VOL +” or “ACCOM VOL -“ at the same time to reset the volume to default.
TIMBRE SELECTION
• There are 255 pre-programmed timbres, labeled from “000” to “254”.
• To select the timbre at any time, press “TIMBRE and” “tnE” will show on the display. Select the timbre by
pressing the corresponding numbers or the “+/-“ buttons.
PLAYING PERCUSSION
• There are 61 keyboard percussions pre-programmed into the keyboard. Press “PERCUSSION” to change the
keyboard to a percussive instrument. Press the button again to stop this function.
PLAYING DEMONSTRATION SONGS
• The keyboard has 24 pre-programmed songs, numbered “d00” to “d23.”
• Press the “DEMO SONG” button to play all demo songs in order. Press the “DEMO SONG” button again to stop
playing the demo song.
• Press the number buttons or “+/-“ buttons during demo mode to select a demo song.
• Press “START/STOP” or press “DEMO SONG” to stop playing the demo song.
To Next Page
Loading...