BCS VALIANT 400 - Page 184



GB
Maintenance table during the first 50 work hours of the tractor (running in)nzPart Operation type Operation to do
Servicing interval Part Operation type Operation to do
Every 10 hours (every
day)
Engine oil Check level Fill up if required
Air filter (2) Check and clean Clean with compressed air at low pressure
Coolant (4) Check level Fill up if required
Coolant radiator Check and clean Clean with a soft brush
Fuel tubes (11) Check for damages Replace if required
After the first 50 hours
(end of running in)
Engine oil Replace
Engine oil filter (3) Replace cartridge
Fuel filter (3) Replace cartridge
Alternator / air conditioner compres-
sor belts (5)
Check tightness Tighten belt
Check for damages Replace if required
Grease points (6) Grease
Tyres Check inflation pressure
Transmission oil Replace
Hydraulic oil filters Replace cartridges
Routine service table
Servicing interval Part Operation type Operation to do
Every 10 hours (every
day)
Engine oil Check level Fill up if required
Air filter (2) Check and clean Clean with compressed air at low pressure
Coolant (4) Check level Fill up if required
Coolant radiator Check and clean Clean with a soft brush
Fuel tubes (11) Check for damages Replace if required
Every 50 hours (every
week)
Grease points (6) Grease
Tyres Check inflation pressure
Hydraulic oil Check level
Every 200 hours
Engine oil Replace
Engine oil filter (3) Replace cartridge
Fuel filter (3) Replace cartridge
Fuel system unions Check for leaks
Alternator / air conditioner compres-
sor belts (5)
Check tightness Tighten transmission belt
Check for damages Replace if required
Rubber tube for air filter intake Check for damages Replace if required
Cooling circuit sleeves Check for damages Replace if required
Hydraulic oil filters Replace cartridges