EasyManua.ls Logo

BCS VALIANT 400 - Page 185

BCS VALIANT 400
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...


Every 500 hours
Air filter (2) Replace
Alternator belt (5) Replace
Tappet gap (8)
Check and adjust if required
Ask an authorized service centre (7)
Every 600 hours
Transmission oil Replace
Hydraulic pipes
Check the integrity
Every 1000 hours
Coolant (4) Replace
Cooling circuit sleeves Replace
Rubber tube for air filter intake Replace
Fuel tank Clean inside Drain and clean inside
Coolant radiator Clean inside
Injectors (9) Calibrate and clean Ask an authorized service centre (7)
Fuel tubes (11) Replace
Every 4000 hours
Timing belt (10) Replace Ask an authorized service centre (7)
Every 5000 hours
Engine Partial overhauling Ask an authorized service centre (7)
Every 10000 hours
Engine Overhauling Ask an authorized service centre (7)
(1) The indicated service interval is only valid if you use the synthetic oil recommended by the engine operation manual, i.e. AGIP SINT 2000 TURBOD-
IESEL
5W40, otherwise the engine oil should be replaced every 100 work hours. If the engine operation hours do not reach the above mentioned value, oil should
be anyway replaced at least once in a year.
(2) Check more often if the tractor is operated in dusty environment.
(3) If the engine operation hours do not reach the above mentioned value, the filter should be anyway replaced at least every 12 months.
(4) If the engine operation hours do not reach the above mentioned value, the coolant should be anyway replaced at least every 24 months.
(5) If the engine operation hours do not reach the above mentioned value, the belt should be anyway replaced at least every 24 months.
In heavy-duty conditions, such as dusty environment and operation with extreme loads, greasing should be carried out more frequently.
(7) This operation should be entrusted to a service centre authorized by the engine manufacturer.
(8) Only for FOCS engines
(9) Only for CHD engines
(10)
The timing belt must be replaced every time it is removed. If the tractor is not used frequently, it should be replaced anyway every 4 years.
(11) Only for rubber tubes. Nylon tubes must not be replaced.

Table of Contents

Related product manuals