How to fix unable to select gear on BCS 710?
If you can't select a gear on your BCS Tractor, it's possible that pressure washing has removed the lubrication from the gear lever detent ball. To fix this, grease the detent ball and quadrant.
Why is my BCS 710 Tractor engine smoking?
If your BCS Tractor engine is smoking, it could be due to petrol in the engine oil, possibly from leaving the fuel tap on during transportation. A simple fix is to change the engine oil. Another cause might be a contaminated air filter, in which case, replace the element.
What to do if I am unable to pull the engine over on my BCS Tractor?
If you are unable to pull the engine over on your BCS Tractor, it might be because the machine was tipped on its side during cleaning, causing engine oil to fill the cylinder bore and create a hydraulic lock. To resolve this, remove the spark plug and air filter, stand to one side, and pull the engine over to clear out the oil. After that, change the engine oil and air filter, and clean the spark plug.
Visual identification of control levers and components for BCS 710 and 728 models.
Visual identification of control levers and components for BCS 738 and 740 models.
Detailed explanation of each control lever and button on the machine.
Procedure for starting the petrol engine, including pre-start checks and operation.
Procedure for starting the diesel engine, including pre-start checks and operation.
Instructions on how to operate the BCS Two Wheel Tractor with various implements.
Steps required to safely stop the engine and the machine.
Recommended service intervals for the BCS Two Wheel Tractor based on time or work hours.
Specific oil quantities and types recommended for the gearbox of BCS models.
To Next Page
General
