Seite 32 von 40
Timer on
: As soon as the desired time is reached, the unit switches on
automatically.
Auto Mode
In AUTO dehumidification, the compressor starts automatically as soon as the
room humidity is 5% higher than the set humidity, the fan runs at the set speed.
If the humidity is 5% below the set humidity, the compressor stops, but the fan
continues to run at the set speed. If the room humidity is between + 5% and -
5% of the set humidity, the unit continues to run until the room humidity is 5%
below the currently set target value.
The default value set at the factory is 50% and can be selected in five steps
between 30% and 80% by repeatedly pressing the "Humidity setting" button.
Continuous Mode
In this mode, the unit runs continuously until it is either switched off, the timer
switches the unit off or the water tank is full, unless the drain hose is used. In
this mode, no target room humidity can be selected.
Dry Mode
In this mode, the unit runs independently of the humidity in the room.
No humidity is shown on the display in this mode and the fan runs at high power
by default
Dry Mode
•
Press the drying button to activate the drying function.
Duration: Approx. 1 hour.
•
The dehumidifier operates at high fan speed and emits air for more than 30
minutes
•
then the dehumidifier changes to low speed and continues to run for
approx 20 minutes.
•
if you press the dry button again, the drying process is interrupted.
Drainage
When using the water tank
When the water tank is full, the appliance switches off automatically and beeps
to indicate that the water tank is full. The tank full indicator lights up.
To Next Page
Loading...