Seite 33 von 40
The dehumidifier only continues to run after the water tank has been emptied.
Place both hands respectively at
the side of the back cover side of
the depression, gently remove
the water tank and open the tank
cover on the right side of the body,
then pour the water from the gap
between water tank and the cover.
Close the tank cover,and rotating
water tank handle down,then put
the water tank gently and put it
back in the right place to restart
dehumidifier.
Note: Check in the water tank that the float is in the correct position. Do
not remove the float and make sure that it can rotate freely. If the float is
removed, the appliance will not recognise when the water tank is full.
When used with drain hose without pump function.
•
By attaching a drain hose (13 mm outer diameter) or a garden hose with
standard thread (26.98 mm outer diameter and 11.5 TPI rivet), the water
can be automatically emptied into a floor drain.
•
At the back you will find the water outlet. Remove the plug.
•
Attach one end of the drain hose to the drain hole.
•
Direct the other end of the hose to a drain.
ATTENTION!
The drain must be in a lower position than the water outlet of
the appliance. Do not place the appliance on the floor and guide the hose
upwards
To Next Page
Loading...