SMART SAFE 3001D-1HL/3HL/5HL
SMART SAFE 3001D 1HL/3HL/5HL
When dOnE display and after one beep sounded, 1
st
service code has been deleted.
Service key can be deleted until the display off
DELETE ALL SERVICE CODE
Make sure that the smart safe was open.
Press the *, 0 and # button, input owner code, and then press # button.
When PrOG display, press the *, *, *,and # button
When dEL ALL display, input owner code and press # button
When dOnE display and after one beep sounded, all of service codes have been deleted.
OPEN THE SAFE BY SERVICE CODE
Press the *, 1~5 and # button, input the corresponding service code that you set before, and then
press # button. (1~5 corresponding service code group 1 to group 5 )
When OPEn display, the door has opened.
SWITCH TO SHARE MODE/ PRIVACY MODE
Switch to SHARE MODE : Press the Reset button last one second, release the button if heard
“Beep”, continuous “Beep” will indicated Share Mode has been activated.
Switch to PRIVACY MODE : Press the Reset button last three seconds, release the button if heard
“Beep Beep”, continuous “Beep” will indicated Privacy Mode has been activated.
CLOSING AND OPENING THE SAFE IN SHARE MODE
To close the safe, the user must keep the door pressed and key the code onto the keyboard, followed by the
key #. This code may consist of anything between 4 and 9 digits, at the discretion of the user. To indicate that
the door has closed, CLSd will show up on the display.
To open the safe, you just need to key in the same code. As you set the code, if you key in a wrong digit, you
can press * to delete it and re-key in the right digit.
You can change the One-Time Code during any safe closing or opening cycle.
CLOSING AND OPENING THE SAFE IN PRIVACY MODE
To close the safe, the user must keep the door be pressed and press the button #. To indicate that the door
has closed, CLSd will show up on the display.
To open the safe, you just need to key in the Owner Code as you set before, In Privacy Mode, don’t need to
key in *, 0 and # any more before key in Owner Code, but should be key in *, 1~5 and # button before
inputting any group of Service Code.
One Time Code will not available when safe work on Privacy Mode.
To Next Page
Loading...
