5
FOR SERVICE: 1-866-850-6662 & WWW.BEPRESSURE.COM
Check engine with
(SAE 30 weight)
engine oil. Oil Level
should read between
hash marks on dip-
stick.
1 2
Attach high pressure
hose to outlet M22
Quick-Connect tting
on frame.
3 4
Ensure the inlet lter
is clean.
Attach Garden hose to
inlet garden hose con-
nector on frame, and
turn on water.
Fill gas tank on en-
gine with unleaded
gasoline only.
6
Push primer bulb
rmly 3 times.
7 8
While holding gun
trigger open with one
hand, pull starter
cord on engine
Slide throttle control
left to “FAST” posi-
tion.
Pull trigger on gun to
purge system of air
(until a steady stream
of water comes out
the nozzle).
5
If engine does not start after 3 pulls, push primer bulb 3 more times,
then pull starter cord again.
START-UP (4
.75
HP)
START-UP PROCEDURE (4.75 HP UNIT)
Observe the below steps, and take care to follow them exactly as shown.
4
.75
HP
To Next Page
Loading...
