OPERATING THE UNIT
OPERATION PROCEDURES FOR ALL UNITS
Be sure to follow the appropriate Start-Up procedure for your pressure
washer before following the below Operation steps.
Grasping the gun and
lance with Both Hands,
hold spray nozzle 8-
24 inches away from
cleaning surface.
1
Pull trigger to spray
water.
2
WARNING
Do not allow unit to run for more than 2 minutes without pulling the trig-
ger. Letting the unit idle for too long can cause the pump to burn out. If
it is necessary to stop your work for more than 2 minutes, turn off the
engine (see Shut Down procedures).
i
NOZZLE USAGE (5, 6.5, 13HP UNITS)
Be sure to choose the correct Nozzle for the job you are performing.
Below are some examples of when to use each.
0
O
15
O
40
O
SOAPER
Thin and powerful
stream of water. Used
for difcult to remove
stains.
Uses a small angle
of spray for focused
cleaning.
Largest angle of spray
used for cleaning sur-
faces quickly.
Soaper nozzle is used
in conjunction with a
cleaning uid. This is
the only nozzle that
can be used with
cleaning solution. (On
5,6.5, & 13 HP Models)
i
i
VARIABLE NOZZLE ADJUSTMENTS (4.75HP UNITS)
Spray Pattern
Left: Shrink
Right: Widen
Pressure
Out: Decrease
In: Increase
Left Right
Out In
To Next Page
Loading...
