8.2. Follow these instructions to change spray tips:
8.2.1. Pull back collar on quick–connect and pull current spray tip off.
8.2.2. Store spray tips in holder provided on the handle. Storing nozzles in the designated holder
will help prevent debris clogging the tip.
8.2.3. Select the desired spray tip:
8.2.3.1. For gentle rinse, select the white 40° spray tip.
8.2.3.2. To scour surface, select the yellow 15° or red 0° spray tip.
8.2.3.3. To apply detergent, select the black spray tip.
8.2.4. Pull back on collar, insert new spray tip and release collar.
8.2.4.1. Tug on the spray tip to make sure it is securely in place.
8.3. Usage tips
8.3.1. For most effective cleaning, keep the spray tip from 8 to 24 inches away from cleaning
surface.
8.3.2. If you get spray tip too close, especially using a high pressure spray tip, you may
damage surface being cleaned.
8.4. Using the Black soap nozzle.
8.4.1. To apply detergent, follow these steps:
8.4.1.1. Review use of spray tips.
8.4.1.2. Prepare detergent solution as required by job.
8.4.1.3. Place the small filter end of the detergent siphoning tube into the
detergent container.
Make sure that the filter is fully submerged in detergent while applying
detergent. THIS WASHER WILL ONLY DRAW SOAP WITH THE BLACK SOAPER
NOZZLE. The WHITE, RED, AND YELLOW NOZZLE WILL NOT DRAW SOAP.
8.4.2. Make sure the black spray tip is installed.
8.4.2.1. Make sure the garden hose is connected to the water inlet. Check that the high pressure
hose is
connected to the spray gun and pump.
8.4.2.2. Turn on water.
You must attach all of the hoses before you start the engine.
Starting the engine without all the hoses connected and without the water
turned ON will damage the pump.
Damage to the equipment resulting from failure to follow this instruction will
void warranty.
8.4.3. Start the engine following instructions ‘Starting Your Washer’.
8.4.4. Apply detergent to surface, using long, even, and overlapping strokes.
8.4.5. Allow the detergent to “soak in” for 5 minutes before washing and rinsing. Reapply as
needed to prevent the surface from drying.
8.4.6. DO NOT allow the detergent to dry on the surface being cleaned.
To Next Page
Loading...
