6 7
conditions. When the water freezes and
expands, your power washer will be
damaged and become inoperable. Or, if
storing outdoors, it is recommended you
use pump saver (not included) to protect
pumps.
26. NEVER use hot water with your power
washer. It will overheat and damage
the high pressure pump.
27. NEVER leave the power washer
unattended while it is powered “ON”.
28. ALWAYS turn the water supply “ON
” before turning the power washer
power to “ON”. Running the pump
dry will cause damage to the internal
components.
29. NEVER use a water supply to your
power washer that exceeds 150 PSI
maximum.
30. NEVER disconnect the high pressure
hose from the power washer while the
system is pressurized.
31. NEVER permanently engage the
trigger mechanisms on the spray gun.
32. NEVER operate the power washer
unless all components are properly
and securely connected.
33. NEVER allow the power washer pump
to run for more than one minute after
you have turned o the water supply.
This can cause the motor and pump to
overheat and fail.
34. NEVER use lances or other parts that
are not compatible for this specific BE
unit.
35. NEVER USE AN EXTENSION
POWER CORD since it defeats
the eectiveness of the GFCI and
increases the chance of electrocuting
the operator.
36. NEVER spray any electrical outlet with
your power washer.
37. Inspect the power cord before using.
DO NOT use it if it is damaged.
Double Insulated
Product
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Servicing of a Double-Insulated
Appliance
Ground Fault Circuit Interrupter
Protection:
This pressure washer is provided with a
ground-fault circuit-interrupter (GFCI)
built into the plugs of the power-supply
cord. This device provides additional
protection from the risk of electric shock.
Should replacement of the plug or cord
become necessary, use only identical
replacement parts that include GFCI
protection.
In a double-insulated product, two
systems of insulation are provided
instead of grounding. Grounding means
are not provided for a double insulated
product, nor should grounding means be
added to the product.
Servicing a double-insulated product
requires extreme care and knowledge of
the system, and should only be done by
qualified service personnel.
Replacement parts for a double-insulated
product must be identical to the original
parts.
A double-insulated product is marked
with the words “Double Insulation” or
“Double Insulated”. Product may also be
marked with symbol shown here.
To Next Page
Loading...
