Beacon LUCCI LCD User Manual

7
Press the LIGHT TIMER buttons to activate the timer function, and then press the UP / DOWN buttons to set
the time at what you preferred. The light will turn OFF at the set time. Light timer can be cancel anytime by
setting the timer to 0 (zero hours).
NOTE: When using the FAN AUTO Function and TIMER function, ensure the remote is in the same room
or within the transmission/receiving range.
TROUBLE SHOOTING:
Warning: For your safety, ensure the power is switched OFF before starting the troubleshooting
procedures
TROUBLE PROBABLE CAUSES SUGGESTED REMEDY
1．
．．
．No functions operate
Warning: Some task can
only to be performed by a
qualified technician.
Main power not restored
Replace fuse. Turn ON circuit breaker.
Turn ON wall switch.
Wall controller is not removed and
interferes with remote operation.
Remove
the fan wall controller, and
replace with ON/OFF switch for remote.
Wall switch power to the
fan
remote is OFF.
Switch wall switch ON
, to power the
remote.
Receiver wiring incorrect.
Verify wiring connections according to
label and wiring diagram.
Transmitter and receiver DIP
switches do not match
Set transmitter and receiver to same DIP
switch setting.
The remote is too far from the
receiver
Move closer to receiver
2. Remote LED/LCD no
display
Battery too weak
Replace with all new batteries. Do
not mix
up the old and new battery.
Battery at wrong polarity Reinstall the battery at right polarity
The contacts in battery
compartment are corroded or bent.
Clean corroded contacts.
Bend contacts back to their correct
position.
Poor contact with batteries.
Roll the batteries to well sit in the
compartment. Or replace with other brand
batteries.
3. Operates only at close
range
Signal blocked from reaching
receiver
Extend antenna out from canopy, or move
it for better reception
Battery too weak
R
eplace with all new batteries. Do not mix
up the old and new battery.
4. More than one fan
remote operating
interference in same area.
RF interference
Change DIP switch
settings to a different
code. Each pair of transmitter and receiver
must have unique DIP switch code.
5
. LCD remote reset to
default value
Batteries lost contact by accidental
dropping of the remote, or battery
is weak.
Reset the setting as you preferred
manually, after re-
fitting batteries or
change of new batteries.

Beacon LUCCI LCD Specifications

General

Brand	Beacon
Model	LUCCI LCD
Category	Controller
Language	English