Why does my Beam Tech BS-600 beep continuously and show a red LED?
If your Beam Tech UPS is emitting a continuous beep and the status LED is red, it indicates the UPS is overloaded. To resolve this, turn off the UPS and unplug some of the connected devices to reduce the load.
Why doesn't my Beam Tech BS-600 provide the expected runtime?
If your Beam Tech UPS doesn't provide the expected runtime, it could be due to excessive loads connected to the UPS or a weak battery. Disconnect the devices from the UPS, leave the UPS plugged in for 10 hours to charge. Test it again, and if the runtime is still not as expected, the battery likely needs replacing.
What to do if my Beam Tech BS-600 has no output when a blackout happens?
If your Beam Tech UPS has no output during a blackout, the cause may be a dead battery. In this case, replace the battery. If this doesn't solve the problem, call for service.
How to fix a Beam Tech UPS button that doesn’t work?
If the button on the front panel of your Beam Tech UPS doesn’t work, the CPU inside the UPS might not be running correctly. Try resetting the UPS by pushing the button for 6 seconds. If this doesn't work, unplug the line cord and all loads from the UPS, and call for service.
What to do if my Beam Tech BS-600 UPS has no reaction when plugged into AC?
If your Beam Tech UPS has no reaction while AC is connected, check the line cord plug to ensure it is properly connected. Also, inspect the fuse on the rear panel (inside the drawer of inlet) and replace it if it's blown. Finally, test the wall socket with a table lamp to ensure it is working.
To Next Page
General